HomeAbout UsproductEnquiryContact Us
 
 
 
 

Electronics

Pages: 1 2 3 4 5 6 [«Back ||Next »]
   

CELL HOLDER

Product Code: PHY-443
Plastic moulded very sturdy rectangular shaped cell holder with cover to hold 1.5 volt dry cell with sockets for output.
PHY-443.1 for one cell
PHY-443.2 for two cells
PHY-443.3 for four cells

   

TRANSFORMER

Product Code: PHY-444
Fitted in elegantly painted metal case, output 2, 4, 6, 8, and 12 V at 8 A through 4 mm sockets workable on 230-240 volt a.c. input.

   

POWER SUPPLY 12 V AC AND DC

Product Code: PHY-445
The power supply is built in suitably sized steel cabinet employing modern technique and circuit; for measuring voltage and current are built in protection with fuse.
  Output current
PHY-445.1 1 Amp
PHY-445.2 2 Amp
PHY-445.3 3 Amp

   

AC/DC POWER SUPPLY WITH HAND

Product Code: PHY-446
ON/OFF switch
Input voltage : 220V 50Hz
DC output : 0-12V, 0-1.5A, stabilized and continuously adjustable voltage, electronic protection. AC
output : 6V, 12V, max 2.5A, fuse protection.

   

POWER SUPPLY, CONTINUOUSLY VARIABLE, 25 V

Product Code: PHY-447
The power supply is built in suitably sized steel cabinet employing modern technique and circuit, meters for measuring voltage ,gives continuously variable a.c. and d.c. outputs up to 10 A for a.c. and 8 A for d.c. A meter is provided to indicated both a.c. and d.c. voltages. An internal fuse is provided for input and a resettable cut-out for output. With mains lead.
Mains input 220-240 V a.c. 50/60 Hz
Output voltages 0 to 25 V a.c. and unsmoothened full wave rectified d.c.
Output current 10 A maximum a.c.,8 A maximum d.c.
Voltage selection Rotary continuously variable transformer operated by a large knob in front panel.
Metering a.c and d.c output voltages by a moving coil meter with selector switch to select a.c or d.c
Circuit protection Mains input 3 A internal glass fuse link. Output is protected by a resettable cut-out.
Output terminals Colour coded 4 mm sockets.

   

POWER SUPPLIES, REGULATED, DIGITAL

Product Code: PHY-448
The power supply is built in suitably sized steel cabinet employing modern technique and circuit, meters for measuring voltage, these power supplies are d.c. regulated, stabilised short circuit and overload protected, easy and safe to use as a power source for electronic equipment. The power supply can be operated in either constant voltage or constant current mode. Both voltage and current are precisely regulated with low output ripple. Voltage and current readings are displayed on two separate 3½ digit meters.
Output voltage, single or double, is continuously adjustable from 0 to 30 volts by coarse and fine controls.
Meters 3½ digital panel meters separately for voltage and current.
Accuracy of DPM 3½ digital panel meters separately for voltage and current.
Regulation ±0.05% for current.,±0.05% for voltage
Ripple less than 3 mv r.ms
Input voltaget 230 volts ±10%, 50 Hz.
PHY-448.1 Capacity 1 Amp
PHY-448.2 Capacity 2 Amp
PHY-448.3 Capacity 5 Amp

   

POWER SUPPLIES, REGULATED, ANALOGUE

Product Code: PHY-449
Same as PHY-448 but output indication is through separate analogue meters.
PHY-449.1 Capacity 1 Amp
PHY-449.2 Capacity 2 Amp
PHY-449.3 Capacity 3 Amp

   

POWER SUPPLY H.T

Product Code: PHY-450
The power supply is built in suitably sized steel cabinet employing modern technique and circuit, meters for measuring voltage, general purpose H.T unit for use with thermionic tubes etc. provides two continuously variable d.c. outputs of 0-25 V and 0-300 V and fixed a.c output of 6.3 V for valve heaters. The two d.c. voltages are continuously and independently variable. Three meters are provided for reading HT, Bias, and LT voltages.
Mains Input 220-240 V, 50/60 Hz
Output HT 0 to 300 V d.c. at 30 mA
Bias 0 to 25 V d.c. at 5 mA
LT 6.3 V a.c. at 2 Amps.
Load Regulation HT ±1%
Line Regulation HT ±0.5%
Output terminals Colour coded 4 mm sockets with one green socket for earthing.
Metering Three meters to measure HT volts, HT current, Bias voltage.

   

MOVING COIL METERS

Product Code: PHY-451
Mounted on a plastic/acrylic stand, with permanent magnets, spring controlled movement, jewelled bearings, hard polished pivots, and knife edge pointer. For D.C. use, each meter is with colour coded terminals.

Scale length approx 50 mm, dial dia 65 mm mounted in desk stand with two colour coded terminals. Overall size 90 x 110 x 90 mm approx. Accuracy: ±2.5% 0-30, 60 Volts.

   

MOVING COIL METERS

Product Code: PHY-452
Same as PHY-468, but dual range.

   

MOVING COIL METERS

Product Code: PHY-453
Same as PHY-452, but Triple range

   

MOVING COIL METERS, SQUARE

Product Code: PHY-454

Mounted on a plastic/acrylic stand. Scale length approx. 60 mm with anti-parallax mirror scale, dial size 72 x 72 mm with colour coded terminals. Accuracy: ±2% fsd


   

MOVING COIL METERS, SQUARE

Product Code: PHY-455
Same as PHY-454, but dual range.

   

MOVING COIL METERS, SQUARE

Product Code: PHY-456
Same as PHY-454, but triple range.

   

VOLTMETER, MOVING COIL

Product Code: PHY-457

For D.C. measurements, any single range 0-1, 1.5, 2, 5, 10, 25, 50, 100, 250,. 300 volts.


   

 
Home|About Us|Products|Enquiry|Contact Us
Copyright © 2009 Lotus Overseas & Marketing (India) - All Rights Reserved.